![]() My first thought was to find a drill-chuck-to-quick-connect adapter, but all stores I've been to don't sell them, only normal quick connect extensions/bits. The length of stud off the backing plate is in the ballpark of 3/8" or 7/16" long. The backing plate has a 5/16" stud (I think around 18 threads per inch). Looking for help on how I can attach the 3" backing plate from my griots 3" DA polisher to my M18 impact driver which has 1/4" drive quick connect (no chuck). (I don't know how this sub feels about links to items for sale, so remove the com/Neiko-20753A-Keyless-Conversion-4-Inch/dp/B007TCHKXW Even if you did dip them in the flame for a second, the worst that will happen is you'll ruin them (though that would take a little doing and a lot more than a brief brushg in the flame), but it's far better than burning your hand. You might want to just buy or craft a holding tool, to keep your hands further away from the flame.Īll of these tools aren't meant to go directly in the flame, but can get really close to the flame. Aim it directly on where you're workingĢ) I'm not sure what your application is, but it looks to me like you are forming a gather on the end of a short solid quartz rod. It could even just a be a clamp on fixture with a nice bright bulb in it. Just increase the general amount of light in the area, to make it easier to see what you are doing before the glass enters the flame. Here are two suggestions that may help you work once you have proper safety glasses in place.ġ) Put a bright lamp on your area. Sunglasses aren't going to filter out the right parts of spectrum, nor filter near the gross amount of light needed to keep your eyes safe. They are actively working to block light from reaching your eyes (in some parts of the spectrum more than others). Yeah, by virtue of quartz working glasses being so dark, you're going to have a hard time seeing through them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |